Solar kW vs kWh: turn a panel rating into an energy estimate

A worked example separates panel watts, system kilowatts, daily kilowatt-hours and specific yield.

By Kyle Bell · Original examples and linked primary references · November 17, 2026

A solar panel's watt rating and a home's electricity use describe different things. The first is a power rating under specified test conditions. The second is energy accumulated over time. Keeping those units separate makes a production estimate easier to check and makes competing proposals easier to compare.

The SAM system-design documentation describes DC nameplate capacity in kilowatts at standard test conditions. It is an input to a production estimate, not a promise that the array produces that power continuously.

Start with the whole array

Suppose a proposal includes sixteen panels rated at 400 watts each. Multiply the panel count by the individual rating:

16 × 400 W = 6,400 W = 6.4 kW DC.

Use 6.4 kW as the array input. Do not enter 400 as though it were the whole system's kilowatt rating. Also do not reduce 6.4 kW by the panel's advertised conversion efficiency. The panel's watt rating already reflects its rated electrical output; applying module efficiency again would count that conversion twice.

Add a sunlight assumption and a loss assumption

For a simple scenario, assume 4.5 peak sun hours per day on the panel plane and a 20% total production reduction. These are illustrative inputs, not a location estimate. The retained fraction is 80%, or 0.80:

6.4 kW × 4.5 h/day × 0.80 = 23.04 kWh/day.

For a 30-day period, multiply again:

23.04 × 30 = 691.2 kWh.

If those same conditions represented every day of a 365-day year, the result would be 8,409.6 kWh. That annual calculation is a flat scenario. Use month-specific sunlight inputs when the aim is to show seasonal production, rather than repeating one month's weather throughout the year.

Keep power and energy comparisons separate

An inverter's kW rating concerns the rate at which power can pass through it. A monthly production number in kWh concerns accumulated energy. A 5 kW inverter and a 691.2 kWh monthly estimate cannot be compared by subtracting one number from the other; their units differ.

Similarly, a home using 30 kWh on a particular day does not necessarily need a 30 kW array. Dividing energy by the assumed productive hours gives a power scale. The usable result still depends on losses, the timing of consumption, the roof and the equipment design.

Use specific yield as a comparison check

Specific yield divides annual energy by DC array size. In this example, 8,409.6 kWh ÷ 6.4 kW equals 1,314 kWh per installed kW per year. This number helps compare two estimates with different array sizes. It is not a panel-efficiency percentage and it should not be reused at another property without checking that property's assumptions.

Save the panel count, panel wattage, array rating, sunlight inputs, total loss percentage and calendar year with the result. Round the displayed energy to a useful level, but keep full precision inside the calculation. A difference of a few decimal places is rarely the meaningful uncertainty; an unverified sunlight or shading assumption can change the outcome much more.

For a location- and design-based model, compare the scenario with PVWatts. A simple arithmetic estimate is useful for understanding inputs; equipment selection and a final production forecast require a site-specific assessment.

Keep learning

Peak sun hours are not daylight hours